Preston Microforce Y-Cables
Use these cables to power and control motors directly from a Preston Microforce controller.
Color and minor length adjustments can be made after adding an item to your cart. Stocked color options can be found here, for special-order color options, please contact me.
All cable orders carry a lead time of up to two weeks for most assemblies, but are subject to extended lead times without notice. Orders cannot be cancelled due to the duration of their lead time, it is strongly suggested to send an email for lead time inquiries if you need a cable by a particular time or date.
All cables are made to order — because of this, any and all custom cable orders are non-cancellable and non-returnable once the checkout process has completed.
All cable orders carry a lead time of up to two weeks for most assemblies, but are subject to extended lead times without notice. Orders cannot be cancelled due to the duration of their lead time, it is strongly suggested to send an email for lead time inquiries if you need a cable by a particular time or date.
All cable assemblies use genuine components and high quality wire. Cables are assembled in California.
Notes
Both power and motor cable leads are assembled to 12 inch (30 cm) by default — a 24 inch (60 cm) combined length.
“3-pin Fischer” cables are assembled with connectors from both Fischer and ODU.
2-pin Lemo power outputs are often fused to prevent overcurrent — a high-amp fused, or unregulated, 2-pin Lemo output may be necessary to deliver power to a Microforce setup.
2-pin Lemo connectors are wired to “ARRI Standard,” pin-1 GND by default.
3-pin Fischer 90° connectors are oriented at 180° from red alignment mark.
Anton Bauer D-Tap/P-Tap cables will exit from negative side of the connector by default.
Lemo 90° Anglissimo connectors can be oriented in eight positions: 0°, 45°, 90°, 135°, 180°, 225°, 270°, and 315°; for reference, standard 90° Lemo connectors are oriented at 180°.
